Darex XPS-16 Operating Instructions Manual de usuario descargar pdf (Pagina 124)

User Manual Page 33

Removing and Replacing the Spindle Arbor Cartridge Assembly

Removing and Replacing the Spindle Arbor Car-

tridge Assembly.

1. Refer to

Grind Motor Belt Replacement

instruc-

tions and remove belt. See Section 24 Sche-

matics and Work Instructions page 29.

2. Remove the 4, 3mm screws on the wheel

cover. Remove, leaving hose attached to

cover.

3. Slide the arbor lock pin through the hole in the

wheel guard casting and rotate wheel until it

engages.

4. With a ½” socket, remove the wheel retainer

nut and remove the wheel.

5. Remove the 4, 4mm screws holding the wheel

casting in place.

The casting is pinned to the cartridge block.

With gentle pressure pull the casting from the

block but do not disconnect any wires. It may

be necessary to tap with a soft mallet. Care-

fully place the casting out of the way.

6. Loosen the 3mm set screw from the drive pul-

ley, but do not remove.

1 2 ... 119 120 121 122 123 124 125 126 127 128

Sin comentarios

Darex XPS-16 Operating Instructions Manual de usuario Pagina 124